10 pasos para una producción ecológica y más eficiente

Reducción de la huella de carbono para una producción ecológica: todo lo que necesita saber
10 pasos para la producción ecológica de aire comprimido

Todo lo que necesita saber sobre su proceso de transporte neumático

Descubra cómo puede crear un proceso de transporte neumático más eficiente.
3D images of blowers in cement plant

Optimice el flujo de aire mediante un controlador central

Nuestro controlador central más reciente, el Optimizer 4.0, estabiliza el sistema y reduce los costes de energía.
Optimizer 4.0 del compresor de aire
Cerrar

Calculating the Working Pressure

Dimensionado Compresores de aire Compressed Air Wiki Instalación de un compresor de aire Guía práctica

The compressed air equipment in an installation determines the requisite working pressure. The correct working pressure does not just depend on the compressor, but also on the design of the compressed air system and its piping, valves, compressed air dryers, filters, etc. Different types of equipment can demand different pressures within the same system.

How do we calculate the working pressure for compressed air equipment?

Calculating the working pressure for compressed air equipment (diagram)
Normally, the highest pressure determines the requisite installation pressure and other equipment will be fitted with pressure reducing valves at the point of consumption. In more extreme cases, the method can be uneconomical and a separate compressor for special needs can be a solution. It should also be kept in mind that the pressure drop quickly increases as flow increases. If a change in consumption can be expected, it makes economic sense to adapt the installation to these conditions. Filters and special dust filters, have a low initial pressure drop, but become clogged over time and are replaced at the recommended pressure drop. This factor will enter into the calculation. The compressor's flow regulation also causes pressure variations and therefore must also be included in the assessment. It may be appropriate to perform calculations using the following example: It is the primarily the end consumer application along with the pressure drop between the compressor and the consumer that determines the pressure the compressor will need to produce. The working pressure can be determined by adding the pressure drop to the system, as shown in the example above.

Read more on the different aspects of dimensioning compressor installations below.

Calculating and Measuring the Air Requirement
airnet tubes pipes service green blue
Calculating and Measuring the Air Requirement
Learn how to calculate the compressed air required to run your different tools.
 
Learn how to calculate the compressed air required to run your different tools.
Learn how to calculate the compressed air required to run your different tools.
Centralization or Decentralization?
AIRnet Stainless steel pipes
Centralization or Decentralization?
Learn more about centralizing and decentralizing a compressor installation.
 
Learn more about centralizing and decentralizing a compressor installation.
Learn more about centralizing and decentralizing a compressor installation.
Dimensioning at High Altitudes
Hilight V4W light tower application
Dimensioning at High Altitudes
Learn more about dimensioning a compressor installation and dealing with a higher altitude.
 
Learn more about dimensioning a compressor installation and dealing with a higher altitude.
Learn more about dimensioning a compressor installation and dealing with a higher altitude.

Related articles