Why optimize your compressed air installation?
Your compressed air system can be an important contributor to your energy bill. Gaining energy efficiency can have a big impact on your cost, while helping to reduce your CO2 footprint.
Increase your compressor efficiency
Energy consumption accounts for up to 70% of the lifecycle cost of a compressed air installation. Atlas Copco’s approach focuses on reducing the overall energy bill, which means that we look through your compressed air installation, from compressed air generation to the distribution network and demand.
Discover how you can maximize your compressor room efficiency.
Understand your compressed air system
Do you know whether your compressed air system is efficient?
With AIRScan, we inspect your entire air system, from the compressors via the air net to the demand side. Based on these checks, we identify potential savings and recommend actions to achieve these savings.
Repair compressed air leaks
Did you know that up to 20% of the energy consumption in your compressed air system could be lost to air leaks? That’s a lot of money you are blowing away. With RePress, leaks are fixed while the distribution net is under pressure, and without dismantling pipes or couplings.
Upgrade your compressor controls
In a multiple compressor installation, compressor control systems contribute to a more accurate pressure output and reduced energy consumption. Upgrading equipment to our latest technologies invariably results in efficiency improvements.
Recover thermal energy
During air compression, heat is generated. This is diverted to the cooling system and released into the atmosphere. However, this thermal energy can be put to good use. That’s where Energy Recovery comes in. It recovers the heat so it can be used for workspace heating, hot water or industrial processes. Your compressor is “creating” energy. Don’t let it go to waste!
Monitor your compressed air installation
SMARTLINK enables you to follow up on the performance and service status of all the equipment in your air compressor room. Detailed reports help you keep track of your energy efficiency, also allowing Energy Management according to ISO 50001.
Read more on compressor optimization
Looking for tips and best practices from industry experts, ways to increase your compressor energy efficiency?
Our blogs have all the answers.
Optimize your installation
Frequently asked questions
Atlas Copco’s approach focuses on reducing the overall energy bill, which means that we look through your compressed air installation, from compressed air generation to the distribution network and demand. We pinpoint the areas where potential savings can be made. We then advise the appropriate actions to optimize the situation. Improving the energy efficiency of your compressed air installation can save you a lot of money.
Our skilled energy audit engineers carry out an air system energy audit with expertise in identifying areas of loss or inefficiencies within your compressed air system. A detailed report highlights the inefficiencies and provides proposals on how to optimize the performance and energy consumption of your installation. A typical AIRScan identifies tangible measures that results in 25-30% energy savings and a significant amount of CO2 reductions. You run the risk of missing out on a significant reduction of your energy consumption by not having your installation audited by our specialists.
Without a central compressor control system, the load/unload pressure of each compressor can be set to react to changes in air demand. If the system pressure drops, an additional compressor will switch to loaded running. However, the sequence will always be the same, and the advantages of a VSD are not fully put to use. The result: higher pressures than required, too much unloaded running and… a steep energy bill.
Find out how our central control system helps you save money.